Tone Generator

Play a low-gain sine tone from 20 to 20,000 Hz for 1–30 seconds, with explicit Play sound and Stop controls.

Generate a low-level sine wave at a selected frequency for a short audio-output check.

Start with a low device volume. Stop immediately if the sound is uncomfortable. This is not a hearing test.

Tone Generator

Play a low-gain sine tone from 20 to 20,000 Hz for 1–30 seconds, with explicit Play sound and Stop controls.

How to use the tool

  1. Lower system volume before playback.
  2. Set frequency and duration within the displayed bounds.
  3. Select Play sound briefly and Stop before the next comparison.

Example and interpretation

A 440 Hz setting creates 440 oscillations per second. A five-second selection controls playback duration; it does not measure speaker response.

Limits

Programmed gain is low but acoustic output depends on volume and hardware. This is not a calibrated signal source, hearing examination or amplifier safety test. Hardware may not reproduce extreme frequencies audibly.

Troubleshooting

Check ordinary playback, browser permission and output selection if silent. Do not raise volume aggressively to chase a high-frequency tone. Hiding the tab stops playback.

Frequently asked question

Does an inaudible tone prove a hearing or speaker fault?

No. Hardware response, output selection, volume, browser behavior and hearing all contribute; this page cannot isolate the cause. Stereo Channel Test helps compare left and right routing, while Frequency Sweep Generator changes frequency during a short run.

Technical reference

OscillatorNode — MDN.