Frequency Sweep Generator

Play a short exponential sine sweep between selected start and end frequencies, with low programmed gain and a 30-second duration limit.

Play a short exponential sine-frequency sweep between two selected endpoints.

Start with a low device volume. Stop immediately if the sound is uncomfortable. This is not a hearing test.

Frequency Sweep Generator

Play a short exponential sine sweep between selected start and end frequencies, with low programmed gain and a 30-second duration limit.

How to use the tool

  1. Lower playback volume.
  2. Set start/end frequencies from 20–20,000 Hz and duration 1–30 seconds.
  3. Select Play sound, use Stop if necessary and compare a separate run.

Example and interpretation

A sweep from 200 Hz to 2,000 Hz over five seconds changes frequency exponentially, not by adding the same hertz amount every second.

Limits

The page generates sound but does not record a microphone or graph room/speaker response. Gain is not calibrated sound pressure. It gives no hearing or speaker pass/fail score.

Troubleshooting

Begin with a moderate range. A buzz can originate in the room, enclosure or playback chain; confirm with a suitable measurement setup before diagnosing hardware.

Frequently asked question

Can I download the generated sweep?

Not in this version. It plays a Web Audio oscillator rather than exporting a sweep file. For one fixed frequency, use Tone Generator.

Technical reference

OscillatorNode — MDN.